Configuration for Online Service Providers

Steps to configure Your SPA-2000 with Free World Dialup

1. If you haven't already done so, sign up for an account at www.freeworlddialup.com. Lets assume that your given phone number is "XXXXX" and your password is "YYYYY"

2. Open a session to the SPA by typing: http://<spa ip address>"

3. Click "Admin Login" link in upper right hand corner"

4. The browser will show a tabbed user interface. Select the Line 1 tab to configure a service for line 1

If you are using NAT do this:

Click "Advanced" at the bottom of the page.

Click "Line 1" tab, and enter the following in the available fields:

Set User ID to your FWD account's FWD number (e.q. XXXXX)

Set Display Name to an identifier to be displayed on callee's CallerID.

Set Password to your FWD account's password (e.q. YYYYY)

Set Proxy to: fwd.pulver.com

Set Outbound Proxy to: fwdnat.pulver.com:5082

Click "Provisioning" tab, set Provisioning Enable: no

Press the Submit All Changes at the bottom of the web page

If you are directly connected to the Internet, do this:

Set User ID to your FWD account's FWD number (e.q. XXXXX)

Set Display Name to an identifier to be displayed on callee's CallerID.

Set Password to your FWD account's password (e.q. YYYYY)

Set Proxy to: fwd.pulver.com

Click "Provisioning" tab, set Provisioning Enable: no

Press the Submit All Changes at the bottom of the web page

5. The Registration State in the Info tab should now display "Registered"

Recommended DialPlan Setting

(DialPlan can be at the bottom page of your line 1 or line 2 tab at:
http://<spa ip address>
Click "Admin Login", then click "advanced")

You can copy and paste the below configuration to your spa:
([*x][*x]x.)

---

Email: sipura-support@external.cisco.com
Fax: 408-955-9855

General Technical Support Hours: 9:00am to 5:00pm PST