Release Notes for -- Linksys SPA-2100 3.3.6

2100 -- 2 Port FXS, 2 Ethernet Interface

Copyright (C) 2006 by Linksys, a Division of Cisco Systems, Inc.

All Rights Reserved.

* * * * * * * * * * IMPORTANT * * * * * * * * * * * * * * * *  *
* Use of Proprietary Information and Copyright Notice:         *
* This release note document contains proprietary information  *
* that is to be used only by Sipura Technology, Linksys(R),    *
* and Cisco Systems, Inc. customers.  Any unauthorized         *
* disclosure, copying, distribution, or use of this            *
* information is prohibited. This restriction includes         *
* ALL Internet based discussion forums, e.g. DSLreports.       *
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *  *


========================================
        Feature Enhancements
========================================
-- since 3.2.9(b) --
. T38 Redundancy made configurable via per-line parameter FAX_T38_Redundancy.

. Support NOTIFY "check-sync" event as NOTIFY "resync" event

. Support <Mark All AVT Packets> option: 
  If set to "yes", all AVT tone packets (encoded for redundancy) will have the 
  marker bit set. If set to "no", only the 1st packet will have the marker bit 
  set for each dtmf event. Default is "yes" (compatible with old behavior).
      
. Changed default ring and call-waiting tone cadence to
  bellcore standard r1-r5 and cwt 1-4

. Change default ring to: 85V, 20 Hz (US std), and trapezoid waveform
                 
. CBQ QDisc is removed from the QoS settings because of the performance.
  NOTE: TBF will be used on all units with CBQ configured once the unit 
        is upgraded
   

========================================
        Bug Fixes
========================================
-- since 3.2.9(b) --

. If first record in a record-route header has an maddr 
   parameter that is specified as a hostname instead of an IP address, the SPA 
   will not try to resolve it and use it to send the next  request (within a 
   dialog); it still uses the host portion of the record istead.
   
. Restric Source IP feature didn't work when both SRV and
   "Auto SRV Prefix" were enabled.
   
. nonce-count (nc) parameter not incremented when reINVITE to
   hold/resume inside a dialog.   

. DMZ router feature didn't work.   

. Unit may reboot randomly under heavy traffic when DMZ is enabled

. Unit may reboot randomly during heavy traffic in NAT mode.

. Dialing could fail to terminate under certain conditions involving rejection 
  of patterns ending in repetition 

. Unit should cold reboot on resync if Primary or Seconday DNS params changed.